A forum post inquired on adapting the following border repeat for use on a punchcard Brother KM, using the lace carriage: the repeat is 14 stitches wide as was given below
Because of repeat restriction in punchcard knitting, the best way to match the above chart is through the use of hand techniques. The image below shows needle bed markings (in water-soluble pen) to help in tracking hand transfers; the long line is the location for the center triple stitch after stitch transfers, the dots place the first single transfers made toward the center long line on the KM, away from the single needle space between them
this is the result of the hand transfers; the fuzz on the left is a manufacturer’s yarn knot
a simplified repeat keeping some of the elements, but missing that center ridge, adjusted to a 12 stitch repeat for use with punchcard; the missing lace hole was an error in punching out the card
the card for it, showing the correction also marked in red
since the intended use is for a border, it is not necessary to punch more than above; the first row for selecting to right with the lace carriage is marked, blue shows location for knitting 2 rows with knit carriage; the sequence is an easy 4 passes with the lace carriage, followed by 2 with the knit carriage
another option’s results, creating the center ridge as in the hand-knit: not identical, but related
the corresponding card: knit 2 rows after every 6 passes with LC, except for the last repeat segment, where LC makes 4 passes prior to continuing with KC and knitting beyond the border
If using cards I would recommend knitting several rows with waste yarn before casting on (as loosely as possible) and continuing in lace. The very bottom will want to curl toward the knit side of the garment, so cast on the edge may require additional treatment to keep it from doing so.
for one more repeat please see next post